Clone mode on d520

[tomi_no]

I build test card with pic16c84. Test mode works fine, but can I access clone mode with this card?

[kuysterm]

Originally posted by tomi_no:
I build test card with pic16c84. Test mode works fine, but can I access clone mode with this card?

Follow the same procedure as for the M3188:
(the order is important!!!!)

1. Remove battery from phone
2. Remove simcard
3. Connect Sim emulator to the phone and the PC's serial bus
4. Run asim.exe
5. Load clone.dat
6. Run clone mode
7. Insert external charger connector, charger must be plugged in mains.
8. While phone's backlight is still on, insert battery or switch on (an) external power supply (4.8V) if no room is available to insert battery.
9. Switch-on phone
10. Clone should appear on the display
11. Download frame one by pressing 021# on the phone
12. After download complete, in asim save frame: e.g. frame1.bin
13. Run Medit: medit frame1.bin > frame1.txt (note the chevron)
14. Edit frame1.txt, e.g. field 113
15. Save frame1.txt
16. Run medit again: medit frame1.bin frame1.txt (note the missing chevron)
17. In asim load new frame1.bin
18. Although it seems as asim is not emulating anymore, it is still doing so. There is no need for starting clonemode again. Press 03# to upload the new frame
19. After "please wait" disappears you're ready!

Please retry 7 to 9 until "clone" will appear on the display. When repeting this sequence _always_ start with a complete switched-off phone before starting with 7 again. It can take many retries on the D520.

Greetings,

Marco


[This message has been edited by kuysterm (edited 24 May 2000).]