e398 dead after flash

[tm-gsm]

I get e398 with soft from E1, i flash this this phne with soft rom e398, and after flash phone is dead. After pres red button, phone schow only bootloader wersion and sw wersion,ok to program etc.....

I try to repair phone with repair pds, and i et this error :

martMoto 1.23
Numer seryjny klipa: xxxxxxxxx, wersja: 2.26, inicjalizacja... OK
Szukanie telefonu... znaleziono S Flash Neptune LTE, Otrzymywanie "zczytywanie" interfejsu testowego... interface nie znaleziony
Przełączanie w tryb flash... OK
Reading phone boot version... 7.D0
Reading flash id... Intel-0x0089
Phone group: V30x,V40x,V50x,V52x,V60x
Reading OTP... error B8
Warning: OTP read failed
Current phone does not correspond model selection

is there any way to repair this phne? or only change flash chip
i think that conect with test point wil not change anything, any idea to repair my phone?

[Mr.Tinkertrain]

@ tm-gsm,

Reading flash id... Intel-0x0089 this string from log file shows that Flash chip can't be read properly. There are two main reasons for that:
1. The flash memory chip is damaged or doesn't communicate with the processor. In this case the phone needs hardware repair.
Connection between the chip and the PCB may be improved by the hot air.
2. Testpoint procedure was not performed properly -- just to make sure please, repeat the tp procedure.

Best Regards
Smart-clip team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[jinto1982]

u can flash it by the flash backup(multiflex tool) with the new full e398 flash file.. this is the good solution if u want e398 flash file plss contact me [email protected]