Error With V360. It´s dead.I Can´t On Phone. Help Please - GSM-Forum

Grupo MovilFree · 01-19-2007, 19:33

I have V360 dead.

Display it´s black, I can´t on and I can´t repair Pds.

How can I repair?

Thankx

Mr.Tinkertrain · 01-20-2007, 10:05

@ Grupo MovilFree,

As your log file shows "Reading Flash id... 0x80 - 0x008, chip unidentify" flash chip can't be read properly. If you have tryed to make Repair PDS using TestPont then possible 2 reasons for such error:
1. The flash memory chip is damaged or doesn't communicate with the processor. In this case the phone needs hardware repair.
Connection between the chip and the PCB may be improved by the hot air.
2. Testpoint procedure was not performed properly -- just to make sure please, repeat the tp procedure.

If you have tryed to make Repair PDS using Prepare function, then the phone needs hardware repair.
Connection between the chip and the PCB may be improved by the hot air.

Best Regards
Smart-clip team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I have a error with Unlock in Nokia 6680. How can I repair it ? Regards	Grupo MovilFree	HWK	4	11-28-2008 03:17
Dead E250 Can flash the phone	ford72	NSPRO	0	04-03-2008 19:39
Need Help ..china N73 When Camera On Phone Shows Please Wait...	CHAPRAN	Infinity-Box	1	01-18-2008 11:21
who have ???Sharp GX 20 Dead !!! Gx20 doesn't power on only blinkin please come here	OMBOSSMAN	Sharp	166	09-19-2005 09:19
Check sim card error fix on BE4 help,please	GreEn	Alcatel & TCL Old Models	0	04-09-2001 08:38

01-20-2007, 10:05	#2 (permalink)
Mr.Tinkertrain No Life Poster Join Date: Feb 2006 Posts: 11,638 Member: 229997 Status: Offline Thanks Meter: 636	@ Grupo MovilFree, As your log file shows "Reading Flash id... 0x80 - 0x008, chip unidentify" flash chip can't be read properly. If you have tryed to make Repair PDS using TestPont then possible 2 reasons for such error: 1. The flash memory chip is damaged or doesn't communicate with the processor. In this case the phone needs hardware repair. Connection between the chip and the PCB may be improved by the hot air. 2. Testpoint procedure was not performed properly -- just to make sure please, repeat the tp procedure. If you have tryed to make Repair PDS using Prepare function, then the phone needs hardware repair. Connection between the chip and the PCB may be improved by the hot air. Best Regards Smart-clip team www.smart-clip.com www.GsmServer.com www.boot-loader.com www.smart-unlocker.com