z6c unlock problem - GSM-Forum

Formingus · 03-07-2010, 20:18

/////////////////////////////////////////////////////////////////////

Orange_Dominica · 03-07-2010, 21:10

Hi...

Remember... this is a dual protocol phone....(CDMA +GSM)....very diffrent than a Z6

Initial Programming Required means that you need to program the NAM and PRL.

If you full flashed the phone...this means your CDMA SPC code has been reset to all 0's ....(000000).

All you need to do now ..is just program the NAM + PRL using the program Motorola RSD CDMA General.

After a successfull write...the phone will boot normally.

:smokin

Formingus · 03-08-2010, 10:38

ok then where to found that NAM + PRL flash to flash it with motorola RSD ?

Formingus · 03-08-2010, 11:49

where are supportersss?

Orange_Dominica · 03-08-2010, 15:00

Hi...

Just write this PRL file using Moto CDMA General. (Phone Provisioning Menu)
For the NAM ...you need to first read it from the phone...make changes to the phone number and write number.

:smokin

03-07-2010, 20:18	#1 (permalink)
Formingus Banned Join Date: Jul 2006 Location: dword ptr [ebp-1C], edx Posts: 4,626 Member: 322417 Status: Offline Thanks Meter: 940	z6c unlock problem ///////////////////////////////////////////////////////////////////// Last edited by GSM_Support; 03-09-2010 at 08:28. Reason: Contained serial number

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
How to Z6c unlock	leventc	Smart-Clip	3	08-13-2010 08:00
how to enter on motorola z6c unlock code	steva	Motorola P2k	3	01-04-2010 23:17
z6c unlock	fares badr	MSS Box II	1	04-26-2009 10:48
Motorolla Z6C unlocking ????	.::BHATTI::.	Smart-Clip	3	04-08-2009 15:45
MOTOROLA Z6C VERIZON unlock problem with codes!!!	Melih22	Motorola P2k	0	11-29-2008 01:49

03-07-2010, 21:10	#2 (permalink)
Orange_Dominica No Life Poster Join Date: Oct 2004 Location: Dominica, West Indies Age: 63 Posts: 646 Member: 88701 Status: Offline Thanks Meter: 381	Hi... Remember... this is a dual protocol phone....(CDMA +GSM)....very diffrent than a Z6 Initial Programming Required means that you need to program the NAM and PRL. If you full flashed the phone...this means your CDMA SPC code has been reset to all 0's ....(000000). All you need to do now ..is just program the NAM + PRL using the program Motorola RSD CDMA General. After a successfull write...the phone will boot normally. :smokin

03-08-2010, 10:38	#3 (permalink)
Formingus Banned Join Date: Jul 2006 Location: dword ptr [ebp-1C], edx Posts: 4,626 Member: 322417 Status: Offline Thanks Meter: 940	ok then where to found that NAM + PRL flash to flash it with motorola RSD ?

03-08-2010, 11:49	#4 (permalink)
Formingus Banned Join Date: Jul 2006 Location: dword ptr [ebp-1C], edx Posts: 4,626 Member: 322417 Status: Offline Thanks Meter: 940	where are supportersss?