v300 - GSM-Forum

elvences · 02-28-2009, 02:22

well I mess up I have a v300 and went ahead and (I repaired pds and I did not have a backup or a flash to flash after wards well now my v300 wont turn on I tried flashing with scout but the phone still death I am open to suggestions please help

togivhelai · 02-28-2009, 02:31

dead??? no bootloader at all ???
if yes
connect via tp procedure then repair pds and try to flash with other firmware..
like:V300_TRIPLETS_G_0B[1].09.56R_lp0034_full_flash.smf (tested many times)

hope this work...
make sure that the battery is atleast 80% full

*note if the unit is shorted because of possible current short during the first unlock attempt possible its PA problem

hope this help

br
titans
tetacs

Orange_Dominica · 02-28-2009, 04:29

Hi
togivhlai is correct...need more information, post log from SCout or SmartMoto
If the phone wont boot at all and no bootloader screen when power is applied..thern hold *+ # and then PWR.
In the event that the above does not work.. short pins 13+14 on the P2k connector with small tweezers and then press PWR.
Dont expect to see bootloader screen ...just connect to SmartMoto and see what it finds after you short 13+14
Good Luck

smokin

elvences · 02-28-2009, 19:49

///////////////////////////////////////////////////////

Orange_Dominica · 02-28-2009, 23:45

Hi
REMOVE YOUR SERIAL NUMBERS
Not Dead ----> Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found
Switching to flash mode... OK

Go to bootloader and download what you need.
Post your SCout or SmartMoto flash log if phoine still wont boot

Good Luck.

,smokin

elvences · 02-28-2009, 23:55

got it working again thanks a lot I only had to get the flash file and finish the whole procedure with smartclip
repair pds
flash phone

02-28-2009, 02:22	#1 (permalink)
elvences Freak Poster Join Date: Jan 2008 Posts: 268 Member: 687490 Status: Offline Thanks Meter: 5	v300 well I mess up I have a v300 and went ahead and (I repaired pds and I did not have a backup or a flash to flash after wards well now my v300 wont turn on I tried flashing with scout but the phone still death I am open to suggestions please help

02-28-2009, 19:49	#4 (permalink)
elvences Freak Poster Join Date: Jan 2008 Posts: 268 Member: 687490 Status: Offline Thanks Meter: 5	/////////////////////////////////////////////////////// Last edited by GSM_Support; 03-02-2009 at 09:29. Reason: Contained serial number

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Alcatel HE1 v300, v 301 unlock? HERE IS INSTRUCTIONS!!!	Lord	Alcatel & TCL Old Models	12	02-05-2004 12:09
Change ESP>ENG lang. OTClub+,HE1,v300	Sandy	Alcatel & TCL Old Models	0	11-30-2000 10:14
Pls,Alcatel OTClub+,HE1,v300 for unlock	Sandy	Alcatel & TCL Old Models	0	11-29-2000 08:45
Unlocked Alcatel OTC v300 is unlocked BUT some times turn OFF (alone) ????	Svetli	Alcatel & TCL Old Models	0	06-12-2000 10:51
how to unlock Alcatel HE1 v300 via Eeprom ??? plz HELP	Svetli	Alcatel & TCL Old Models	10	06-05-2000 18:34

02-28-2009, 02:31	#2 (permalink)
togivhelai Insane Poster Join Date: Apr 2008 Posts: 60 Member: 748214 Status: Offline Thanks Meter: 11	dead??? no bootloader at all ??? if yes connect via tp procedure then repair pds and try to flash with other firmware.. like:V300_TRIPLETS_G_0B[1].09.56R_lp0034_full_flash.smf (tested many times) hope this work... make sure that the battery is atleast 80% full *note if the unit is shorted because of possible current short during the first unlock attempt possible its PA problem hope this help br titans tetacs

02-28-2009, 04:29	#3 (permalink)
Orange_Dominica No Life Poster Join Date: Oct 2004 Location: Dominica, West Indies Age: 63 Posts: 646 Member: 88701 Status: Offline Thanks Meter: 381	Hi togivhlai is correct...need more information, post log from SCout or SmartMoto If the phone wont boot at all and no bootloader screen when power is applied..thern hold *+ # and then PWR. In the event that the above does not work.. short pins 13+14 on the P2k connector with small tweezers and then press PWR. Dont expect to see bootloader screen ...just connect to SmartMoto and see what it finds after you short 13+14 Good Luck smokin

02-28-2009, 23:45	#5 (permalink)
Orange_Dominica No Life Poster Join Date: Oct 2004 Location: Dominica, West Indies Age: 63 Posts: 646 Member: 88701 Status: Offline Thanks Meter: 381	Hi REMOVE YOUR SERIAL NUMBERS Not Dead ----> Searching for phone... found S Flash Neptune LTE, getting test interface... interface not found Switching to flash mode... OK Go to bootloader and download what you need. Post your SCout or SmartMoto flash log if phoine still wont boot Good Luck. ,smokin

02-28-2009, 23:55	#6 (permalink)
elvences Freak Poster Join Date: Jan 2008 Posts: 268 Member: 687490 Status: Offline Thanks Meter: 5	got it working again thanks a lot I only had to get the flash file and finish the whole procedure with smartclip repair pds flash phone