Shine /KE970/ IMEI???

[ceru]

I just flashed a shine mobile witk vygis V1.22 SC, and the imei had changed.
How can I rewrite the imei back?
I tried via vygis box with KG800 cable, and with oiginal native LG shine cable over USB port (of course the correct modem port was changed), but no IMEI read or write was succesfull.
Proggy always says:"Operation failed..."
The cables are good, shine and kg800 flasing (and imei for kg800 also) are properly working (I can't write the imei also for KG800 when the phone is powered on, I can do only if the proggy boots the phone, but this function is not available in LGI proggy).

What could be the problem?
If anybody can help me, please do it!

B.R.:
Ceru

[vygism]

For KE970 IMEI can't be changed by writing other flash or eeprom,as it has IMEI in OTP area One possible way is via software.Now what problems can be-you must use KG800 cable,which goes to box-usb cable can't be used for this.Would be fine of course to check also if cable is correct-simply try to read "Read info" in "Special" section,using LG_1_80SC.If phone info can't be readed-something wrong with cable.Also sometimes is good to press few times "C" on phone,when software reads IMEI or writes it.And most important thing-phone must be ON and without SIM card.

Regards,Vygis

[ceru]

Thanks for the reply Vygism!
The cable is good (of course, KG800 can be flash and write imei, Shine also can be flash via this cable), but can't read info (or write imei) when the phone is turned on (KG800 also can't read info when the phone is turned on).
I think the problem is in the SW, but I hope I made mistake...
How can I describe, where is the problem?

[Gobi]

What mr Vygis was telling you is that you have to use THE CORRECT cable that works thru the VygisToolbox - (PINOUT AVAIABLE IN SUPPORT SECTION), and NOT the USB cable with the modification.
With the modified USB cable you can FLASH the phone ONLY, but canNOT do other operations.

So, if you canNOT read info - then most probably you are using the wrong cable.
Just check your cable with the avaiable pinout on support are.

regards,
Gobi

[ceru]

Thanks for Your quick reply Mr. Gobi!
I had browsed the support area, and find only this in 'Pinout info.txt':

****************************KG320,KG800 pinout***********************************

keybord up

18.............1

7 - RX (data to phone)
6 - TX (data from phone)
1,4,14,18 - GND

Is this the correct pinout?

Thanks:
Ceru

[Gobi]

Yess, it is indeed.
Don't forget that Tx from Phone goes to Rx of box and so on ...

regards,
Gobi

[ceru]

Thanks again, Mr Gobi!
I'll prepare my cable, and will post the results!

Regards:
Ceru

[vygism]

Mostly important is to check all contacts connected to GND.For flashing is enough RX,TX and one GND-for IMEI changing is needed to have all contacts shown in pinout connected to GND.

Regards,Vygis