MT-BOX Flash 5700 die ???help me ple!!!
 

why Flash 5700 die ???help me ple!!!:confused::mad:
log:

Selected Highest installed version: 03.27
Using Tx2 Data line.
Processing File: rm230_03.27_prd_core.fpsx
Boot...
RAPIDOv102_2nd.fg
RAPIDOv11_algo.fg
Erase RAP3 [00040000 - 00082FFF]
Erase RAP3 [00083400 - 0087FFFF]
Erase RAP3 [00B80000 - 052FFFFF]
Erase[79.75 MB]...
Waiting response for 320 Sec...in 1.38s
Flash[42.30 MB]...in 61.03s
* * Processed file in 71.06 seconds
Processing File: rm230_03.27_prd_uda_erase.fpsx
Boot...
RAPIDOv102_2nd.fg
RAPIDOv11_algo.fg
Erase RAP3 [05300000 - 07B3FFFF]
Erase[40.25 MB]...
Waiting response for 320 Sec...in 0.78s
Flash[0.00 MB]...in 0.02s
* * Processed file in 27.80 seconds
Extract content...fail
Processing File: rm230_03.27_prd_v16_01_vietnam.fpsx
Boot...
RAPIDOv102_2nd.fg
RAPIDOv11_algo.fg
Erase RAP3 [03500000 - 052FFFFF]
Erase[30.00 MB]...
Waiting response for 320 Sec...in 0.64s
Flash[16.21 MB]...in 23.81s
* * Processed file in 32.94 seconds
* * * Phone flashing done in 3:34 minutes
Post Flash serial tunning of phone....
Pooling mode for full factory set...
Phone not responding, try to set manually!

Go to automatic whiles flashing and deactive use Tx line. Then flash phone again.

do you really have connected tx2line in cable?

HOW to connect this line???
can you explain pls...
which pin is Rx2
on 5700
i have dead phone now, canNOT be flashed

take little fantasy man.
pinout is a like 6300.

I managed to make FBUS cable for N95 cause of the clear pinout by MT but this one is little hard to understand.Do u have any clear (like the one for N95) pinout so that it'd be easier for us.
Thanks in advance.

It's so helpfull if we have RJ45 pinout too.Both heads i mean r needed here.

What Is Not A Clear -this Is From Service Manual Dont Have A Most Good Picture.this Is Only To See Where Is Tx2line Pin This Is Not A Shematic Of A Cable

Is there any schematic.I need to know where Tx2 must be connected to.I really need it.
The ones like N95 is quite clear and helpful.Hope someone can upload anything like that.

download mt-box pinout from here or support site need to be on a gray wire from 10 pin utp

i searched all through mt support but can't find pinout for 5700.