S8300 psw forgotted usb not work, how to?

[.:Ripgsm:.]

Hi, I have a big problem.
I have a Samsun S8300 which, unfortunately, my son does not remember 'the PSW access.
It 's a big deal'cause through BOX not allowed because the USB connector is repaired only to charge the phone, because the tracks had been torn, so I can not access via USB.
Via code, I can not get in because as you know the phone does not accept symbols, but only numbers, I tried in many ways, but to no avail.
I saw that this phone does not have access to the back of the pin with a RJ, or at least I do not see them.
Is there someone who would be able to help me solve this small but BIG PROBLEM?
BR
MAX

[zorgy_1979]

In this situation you can use only jtag solution. Flash phone by unlocked full by jtag box

[.:Ripgsm:.]

Originally Posted by zorgy_1979

In this situation you can use only jtag solution. Flash phone by unlocked full by jtag box

NO, yesterday I removed I8910 wrong with a BOOT and is not seen via USB, but with the JIG, connected to the RJ45 and RJ45 wires precisely No. 4, 5 and 7, respectively, RX, TX and GND, I managed to do with NS PRO RESET codes, went successfully, but only without using the USB cable connected to the RJ45 BOX JIG and on the back of the phone.
Now, the I8910, there are points to connect the JIG, the S8300 but I saw that behind there is no, but 'by opening the phone, there are 10 points, which I believe are connected to the JIG, (can not be a coincidence who are 10 as are those of the 10 I8910), so if someone could tell me what are the points to touch on the S8300 with this modified RJ45 cable, I'm sure I can reset this at least PSW, then everything else can do it calmly, even FLASH, if I can show it as a kind of "Autoignition", everybody can help to me in this?
Thanks
BR
Max