IPhone 8 Plus U2 (U6300) pare with the motherboard?
 

hi everyone

i've got an iPhone 8 plus dead not working and not charging it doesnt turn on with a charged battery either. so i replaced U6300 (U2) that i got from another iphone 8 working board. now the device turns on but stuck on apple logo i connected to the itunes and itunes detect the device for a second and ask to press trust but the phone still shows apple logo and reboot, i put the old ic back on the motherboard now it's only shows apple logo and when you press home button the homebutton works and vib but still on apple logo so i was wondering if U6300 is replaceable? or it's pare to the motherboard same as bb cpu??

only Rehot audio ic working 100%
 

only Rehot audio ic working 100%

https://d3nevzfk7ii3be.cloudfront.ne...vcKMNdy.medium

Thanks for your reply, but this photo is for iPhone 7 and the one i’ve got is iphone 8 plus?

if hang apple logo home button click vibrate try IOS update first hope so solve your problem I do same on iPhone 7/7+ 8/8+ mostly solve problem. if not then go for hardware for Big Audio IC or jumper pad or reball….

tried to rehot Audio IC and BB PMIC still the same tried another U6300 Backlight is gone for some reason must be M5500 effected by heat, but the phone turns on and boot once i tried to get a back up it turns of and turned on again, replaced U6300 again backlight came back and still shows apple logo home button press but nothing more, it's too complicated

Do you resolve this iPhone 8 Plus ? In most cases you need to reball / replace Audio IC instead just to rehot.

this device seems having more than one problem, i end up reballing audio ic and bb pmic and hard disk the device turned on for awhile and booted but kept showing no sim message every 20 seconds and this problem caused by a short on baseband section so i left the device came back next day and it's only draw 001 Am when i press power button and doesn't turn on or goes to dfu or show apple it's completely dead , found a short on C319_E and this short could be the cause the device stuck on apple logo, removed C319_E short is gone but still the device stuck on 001 when i try to press power button. replaced U3300 Tigris IC and USB ic U6300 and reballed nand flash again, checked all voltages that are generate by PMIC all voltages are present, there is no short on VDD main or VDD boost or any other power rails. my experience says it's the CPU either dead or need reball, because a working iphone even if you remove nand flash or remove RAM it still draw 006 and can connect to itunes in DFU mode and this iphone 8 plus can't connect to itunes and only draw 001 all necessary power rails are present to turn the CPU so it must be the CPU itself, regarding to when the device booted first time there was no backlight and second time i got it to boot there was backlight but touch wasn't working :confused: so confusing

A big headache to rearange all components well back ... Mostly after droping is possible to have more that one damage, due to they are so big units and floor kiss is painful . The change of U6300 was good move to make it responsive to USB connection, but imposibility to touch TRUST come to bad working touch panel [ easy to change / test ] or damaged Audio IC [ if not touch panel ] ... but to mouch components now are affected and probably more cracks opened after board repair. Smell like well damaged board.

i need big help i tried to change iPhone 8plus back but accidentally hit the charger flex during process there was a spark now phone dead.any help on what to change on board to get phone working again please customer coming in few hours