Can't init EMMC, Reason: CARD Operation Condition Timeout Error
 

i try connect s3 no product name so like this

Z3X EasyJtag Software ver. 1.5.1.0
Loading eMMC Addon Firmware... IO: 1850 mV
Box S/N: 171xxxxxxxxxxx, ,FW Ver.: 01.50
CMD Pullup Level:1381 mV
CMD Active Level:1825 mV
Can't init EMMC, Reason: CARD Operation Condition Timeout Error
===================================
Done.

what problem ,pls help me all user and supporter.

doudble chec wire or may be damage emmc



br

same problem check wires ,all ok same error n7108 and n7100 two phones ?

im 20 pcs VT EMMC "CARD Operation Condition Timeout Error"

emmc dead :)

I wrote many many times ago. This kind of eMMC cards are not responding on most commands. Unable to make any operations. Only replacement.

Connection are ok if you got this error.

mmm i have the same prob

bro some eMMC chip first connect is ok but after use Repair 00000
it go to Can't init EMMC, Reason: CARD Operation Condition Timeout Error
y like this?

Yeah I got a similar case as this one
earlier Emmc was 00000 I repaired, and now it can't be detected !

Z3X EasyJtag Software ver. 1.5.9.0
Loading eMMC Addon Firmware... IO: 1850 mV
Box S/N: 0B00501xxxxx, ,FW Ver.: 01.50
CMD Pullup Level:1206 mV
CMD Active Level:1577 mV
Can't init EMMC, Reason: CARD Operation Condition Timeout Error
===================================
Done.

I am trying to read a SDIN5D2-2G eMMC chip using the esocket and the Z3X-Pro Easy Jtag device. The chip is recognized but when I try to read it I get the error "Read Check Failed, Reason: CARD Data FIFO Timeout Error". Can you tell me how to correct this error?

error reason

1.wrong sold 3.3v ( vcc)

not wrong solder with 3.3v

i tell Detail ready about problem

I Check This problem On 2 pice of GT-p3100 and solved via this way.:confused:

So i Post here.

Brother I have Samsung Grand G7102 dead with downgrade flashing I am trying direct emmc but getting same error.

Have any idea?


Best Regards.
Siddeque.

same problem here


Z3X EasyJtag Software ver. 1.5.1.0
Loading eMMC Addon Firmware... IO: 1850 mV
Box S/N: 171xxxxxxxxxxx, ,FW Ver.: 01.50
CMD Pullup Level:1381 mV
CMD Active Level:1825 mV
Can't init EMMC, Reason: CARD Operation Condition Timeout Error
===================================
Done.