Samsung j320fn dead

[ChandruChiyyan]

i got samsung j320fn dead condition i tryed to write by vendor after write allso mobile in dead condition so i tryed to write full Dump still phone in condition ...


here is the log:

Setting interface to EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 24 Mhz
CMD Pullup Level: 1831 mV
CMD Active Level: 1859 mV
EMMC Device Information :
EMMC CID: 150100514E3136424200A068DC8BA3DF
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400D
EMMC Manufacture : SAMSUNG , EMMC NAME: QN16BB , HEX: 514E31364242 , S/N: A068DC8B , rev. 0x00
   EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
   EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
   EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01) 
Boot configuration [179] / Boot Bus Config [177] / H/W Reset Function [162]: 0x08 / 0x00 / 0x00
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Backup saved: QN16BB_A068DC8B_20190508_160525.extcsd
EMMC Init completed.

Operation: Writing all eMMC Regions...

Operation: Writing BootConfig ...
Reg: 179  Value: 0x08
Reg: 177  Value: 0x00
Reg: 162  Value: 0x00
Done

Writing to: ROM2 , start: 0x000000000000 , size: 0x000000400000
Filename: EMMC_ROM2_QN16MB_417255979_00000000_00400000.bin
eMMC switching to ROM2
Writing partition...
Done writing partition. Write speed: 1029.61 KB/s

Writing to: ROM3 , start: 0x000000000000 , size: 0x000000400000
Filename: EMMC_ROM3_QN16MB_417255979_00000000_00400000.bin
eMMC switching to ROM3
Writing partition...
Done writing partition. Write speed: 1029.09 KB/s

Writing to: ROM1 , start: 0x000000000000 , size: 0x0000A1000000
Filename: EMMC_ROM1_QN16MB_417255979_00000000_A1000000.bin
eMMC switching to ROM1
Writing partition...
Error writing at address: 00007B160000 , error: -8, DATA SND CRC Error(Small ROM Size, maybe) ... Retry #1
Done writing partition. Write speed: 2687.72 KB/s

All done   time: [00:16:31:393]

Setting interface to EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 24 Mhz
CMD Pullup Level: 1828 mV
CMD Active Level: 1860 mV
EMMC Device Information :
EMMC CID: 150100514E3136424200A068DC8BA3DF
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400D
EMMC Manufacture : SAMSUNG , EMMC NAME: QN16BB , HEX: 514E31364242 , S/N: A068DC8B , rev. 0x00
   EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
   EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
   EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01) 
Boot configuration [179] / Boot Bus Config [177] / H/W Reset Function [162]: 0x08 / 0x00 / 0x00
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Backup saved: QN16BB_A068DC8B_20190508_162204.extcsd
EMMC Init completed.

Scanning soft partitions
GPT header is found and is valid
Partition: SBOOT, [000000400000 - 000000600000], size: 000000200000 (2.00 MB)
Partition: SBOOT2, [000000600000 - 000000800000], size: 000000200000 (2.00 MB)
Partition: l_fixnv1, [000000800000 - 000000900000], size: 000000100000 (1.00 MB)
Partition: l_fixnv2, [000000900000 - 000000A00000], size: 000000100000 (1.00 MB)
Partition: pm_sys, [000000A00000 - 000000B00000], size: 000000100000 (1.00 MB)
Partition: rsvdfixnv1, [000000B00000 - 000000C00000], size: 000000100000 (1.00 MB)
Partition: l_ldsp, [000000C00000 - 000001000000], size: 000000400000 (4.00 MB)
Partition: l_modem, [000001000000 - 000002000000], size: 000001000000 (16.0 MB)
Partition: l_gdsp, [000002000000 - 000002400000], size: 000000400000 (4.00 MB)
Partition: l_warm, [000002400000 - 000002800000], size: 000000400000 (4.00 MB)
Partition: FOTA_SIG, [000002800000 - 000002900000], size: 000000100000 (1.00 MB)
Partition: l_runtimenv1, [000002900000 - 000002A00000], size: 000000100000 (1.00 MB)
Partition: l_runtimenv2, [000002A00000 - 000002B00000], size: 000000100000 (1.00 MB)
Partition: td_runtimenv1, [000002B00000 - 000002C00000], size: 000000100000 (1.00 MB)
Partition: td_runtimenv2, [000002C00000 - 000002D00000], size: 000000100000 (1.00 MB)
Partition: PARAM, [000002D00000 - 000002F00000], size: 000000200000 (2.00 MB)
Partition: efs, [000002F00000 - 000004300000], size: 000001400000 (20.0 MB)
Partition: prodnv, [000004300000 - 000004800000], size: 000000500000 (5.00 MB)
Partition: RESERVED2, [000004800000 - 000004E00000], size: 000000600000 (6.00 MB)
Partition: KERNEL, [000004E00000 - 000006200000], size: 000001400000 (20.0 MB)
Partition: RECOVERY, [000006200000 - 000007600000], size: 000001400000 (20.0 MB)
Partition: PERSISTENT, [000007600000 - 000007700000], size: 000000100000 (1.00 MB)
Partition: PERSDATA, [000007700000 - 000008000000], size: 000000900000 (9.00 MB)
Partition: CACHE, [000008000000 - 000014800000], size: 00000C800000 (200. MB)
Partition: SYSTEM, [000014800000 - 000094800000], size: 000080000000 (2.00 GB)
Partition: HIDDEN, [000094800000 - 0000A1000000], size: 00000C800000 (200. MB)
Partition: userdata, [0000A1000000 - 0001D1400000], size: 000130400000 (4.75 GB)
GPT header successfully parsed

Get firmware version

Brand = samsung
Manufacturer = samsung
Device = j3xnlte
Model = SM-J320FN
Phone platform = sc8830
CPU Abi = armeabi-v7a
Android release = 5.1.1
Firmware version = LMY47V.J320FNXXU0APC6
Firmware date = Sat Mar 12 17:59:03 KST 2016

[layder]

you write boots (J320FNXXU0APC6)

you need write boots with not older boot with this device are worked

restore boot for Samsuns is requared are write latest BL files

find firmware with latest boots and write it by vendor