Bnd-tl10 8.0.0 frp not done

[fatistar]

SigmaKey v.2.30.03
656303049 Sigma dongle 2.30, Initializing...OK
Pack 1: Not activated
Pack 2: Activated
Pack 3: Activated
--------- 2019-04-08 22:47:35 ---------
SigmaKey 2.30.03 HiSi: Remove FRP / Huawei ID
Phone model: BND-TL10
Version: :BND-TL10 8.0.0.366(C01)
Preparing...The phone is NOT connected properly. Read the manual at the official site for details.
Note that operation will fail for new Android security patch levels.
--------- 2019-04-08 22:48:01 ---------
SigmaKey 2.30.03 HiSi: Remove FRP / Huawei ID
Phone model: BND-TL10
Version: :BND-TL10 8.0.0.366(C01)
Preparing...The phone is NOT connected properly. Read the manual at the official site for details.
Note that operation will fail for new Android security patch levels.
--------- 2019-04-08 22:48:21 ---------
SigmaKey 2.30.03 Qcom: Remove FRP / Huawei ID
Android Sooner Single ADB InterfaceCommand not allowed
--------- 2019-04-08 22:48:32 ---------
SigmaKey 2.30.03 HiSi: Remove FRP / Huawei ID
Phone model: BND-TL10
Version: :BND-TL10 8.0.0.366(C01)
Preparing...The phone is NOT connected properly. Read the manual at the official site for details.
Note that operation will fail for new Android security patch levels.

[GSM_Support]

@ fatistar,

Detailed manual on how to service current phone model available by this link.

Please notice, in case phone has latest security patch installed, it can not be serviced, at the moment.

Best Regards
GSMServer team

[fatistar]

SigmaKey 2.30.03 HiSi: Remove FRP / Huawei ID
Connecting....
Android Adapter PCUI (COM9), Provider: HUAWEI Technologies CO.,LTD, Driver ver.: 1.0.24.0, Date: 18/12/2015, USB\Vid_12D1&Subclass_13&Prot_22
....You should activate required PACK to work with this model.
For more information visit www.sigmakey.com
--------- 2019-04-09 18:56:41 ---------
SigmaKey 2.30.03 HiSi: Remove FRP / Huawei ID
Connecting...Reboot phone and try again
--------- 2019-04-09 18:57:00 ---------
SigmaKey 2.30.03 ADB: Remove FRP
^ Android Composite ADB Interface
Cancelled

[GSM_Support]

@ fatistar,

FRP Remove

• Select "HISILICON" platform from the tab menu in the upper left side of the software
• Go to "Service" tab
• Turn the phone OFF
• Set the phone to FastBoot mode:
  • press and hold “VOL-“ button and connect the phone to PC, using USB cable (or use any other method)
• Select “Android ADB interface” port
• Press “Remove FRP” button
• The message "Unlock done… OK" indicates that procedure has been completed successfully
• Disconnect the device

Best Regards
GSMServer team