ip4S RSIM 10 O2UK -> Tmobile activation loop?

[Michal:D]

Hello,

i am new to RSIM, so maybe i am doing something wrong, but i cant get properly working unlock for iPhone 4S (locked to UK O2). I made these steps, but i will end with activation required error..

1. DFU restored iphone 4S (locked to UK Tesco O2)
2. inserted tmobile simcard+ RSIM 10 (10.1)
3. from RSIM popup i select UK O2 (original/locked provider), after i4S, and at last "For 4S 2G/3G SIM Card" (setup OK - accepted)
4. reebooted iphone and successfully activated via wifi/or itunes
(but i dont have signal)
5. goes to settings-phone-sim application- SelectCarrier and change to input imsi
6. enter correct imsi for t-mobile carrier, select "For 4S 2G/3G... " - confirm/accept "setup OK message"
7. reboot phone
8. After reboot i got message "update completed" and activation required
but activation end with "SIM Not Valid"
If i remove sim -> activation screed dissaperad and phone goes to homescreen
If i set RSIM back to O2 UK settings / activation success (but no signal)
If i change RSIM settings to tmobile (after switch it to O2 where activation goes though) i end again on activation needed page...

what i am doing wrong?


thanks for any advice..

[lucasmaster]

Probably broken iPhone, check if You get signal without R-SIM, put working simcard and wait for signal (of coure You will not skip activation) but You must have signal. NO SIGNAL = BROKEN PHONE.

[ogel2]

Here in indonesia, I can even use verizon 4s with RSIM 7+...

Maybe its local network related