detect emmc failed 60 need help - GSM-Forum

alkim · 05-19-2018, 09:04

team my box always says this error and no one in my phone was connect

in other jtag box is good only in emmc pro are failed...i tried all pull up resistor

but not done..
can you post the pin-out directly in box i mean is i suspected my adopter maybe is damage or bad. i need direct pin-out from box where is the location of cmd.d10.etc can you give the image or diagram thanks

asap...

alkim · 05-19-2018, 12:06

where is exactly pin-out of this wire
where is cmd Data0 vcc vccq clk etc

habib.habib88 · 07-19-2018, 01:18

05-19-2018, 09:04	#1 (permalink)
alkim No Life Poster Join Date: Mar 2009 Location: earth Posts: 1,430 Member: 992568 Status: Offline Sonork: kulit Thanks Meter: 231	detect emmc failed 60 need help team my box always says this error and no one in my phone was connect in other jtag box is good only in emmc pro are failed...i tried all pull up resistor but not done.. can you post the pin-out directly in box i mean is i suspected my adopter maybe is damage or bad. i need direct pin-out from box where is the location of cmd.d10.etc can you give the image or diagram thanks asap...

07-19-2018, 01:18	#3 (permalink)
habib.habib88 Freak Poster Join Date: Dec 2007 Posts: 125 Member: 642767 Status: Offline Thanks Meter: 27	Last edited by habib.habib88; 07-19-2018 at 01:23.

05-19-2018, 12:06	#2 (permalink)
alkim No Life Poster Join Date: Mar 2009 Location: earth Posts: 1,430 Member: 992568 Status: Offline Sonork: kulit Thanks Meter: 231	where is exactly pin-out of this wire where is cmd Data0 vcc vccq clk etc