Quote:
Originally Posted by allumts Replace EMMC.
Or if you are good to find Pinout for this model write Dump of Rom 1 /2 and UA read from other same Working phone plus you first Ext_CSD saved of you phone. Use procedure with "Factory Reset" Emmc first of all this.
Read more in Sticky Thread.
Br
allumts |
Code:
======================================================
======================================================
eMMC Test Point Connection Module
======================================================
======================================================
1. DO NOT USE THE PHONE"S BATTERY
2. Connect the Soldered TP Connections to ATF Box
3. Disconnect the USB Cable and Wait until the
the ATF Software will tell you to Connect the USB.
ERROR: EMMC WAS NOT Detected! (CMD1)
Check your Test Point Soldering!
CMD1 Reply: 0x5E5E5E5E
sir i did all the procedure according to your giving instruction with 4 in 1 adapter v3 but i am facing the above mentioned log problem while i tried to connect the pcb with the software. Please tell what might be the problem and what i have to do next to connect the pcb with atf please i will be very thank full to you.