Z3X EasyJtag Software ver. 2.5.0.7
Loading eMMC Addon Firmware... IO: 1800 mV
Box S/N: 0B00100EE1608FB2, ,FW Ver.: 01.58
CMD Pullup Level:1701 mV
CMD Active Level:1763 mV
Box IO Level:1800 mV
CLK Rate:14000 khz
HiPower mode is off!
---------- eMMC Device Information ----------
EMMC CID : 90014A4834473164040509A29DCCB1E8
EMMC CSD : D02701320F5903FFFFFFFFEF8A4040D2
EMMC Manufacturer ID: 0090 , OEM ID: 014A
EMMC Date: 11/2014 Rev.0x5
EMMC NAME: H4G1d , S/N: 161652172
EMMC NAME (HEX): 48344731642000
EMMC ROM1 (Main User Data) Capacity: 3728 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x48.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H4G1d _ 161652172_20170226_1720.extcsd
Searching for partition tables...
Partitioning not detected...
Done.
Running:JEDEC: Partitions config burn...
Z3X EasyJtag Software ver. 2.5.0.7
Skip loading eMMC Addon Firmware
CMD Pullup Level:1701 mV
CMD Active Level:1763 mV
Box IO Level:1800 mV
CLK Rate:14000 khz
Partition configuration:
No enhanced user data area
User partition write reliability: on
No GP1 partition
GP1 write reliability: on
No GP2 partition
GP2 write reliability: on
No GP3 partition
GP3 write reliability: on
No GP4 partition
GP4 write reliability: on
Partitioning successful, power-cycle to make effective
HW Parts Config Done.
