realme c2 not connect with jtag always show cmd time out error realme c2 some time connect with box via isp but most of time
gives cmd time out error
Qualcomm based emmc always connect in first try
please give some solution
here is log
Z3X EasyJtag Software ver. 3.7.0.17
Loading eMMC GEN2 Firmware... IO: 2800 mV
Box S/N: 8C30F9F3F3B1121F, ,FW Ver.: 02.52
CMD Pullup Level:1884 mV
CMD Active Level:2233 mV
Box IO Level:2800 mV
CLK Rate:18000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.
Z3X EasyJtag Software ver. 3.7.0.17
Loading eMMC GEN2 Firmware... IO: 2800 mV
Box S/N: 8C30F9F3F3B1121F, ,FW Ver.: 02.52
CMD Pullup Level:1882 mV
CMD Active Level:2235 mV
Box IO Level:2800 mV
CLK Rate:18000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.
Last edited by dev.saini; 07-24-2020 at 08:59.
|