GSM-Forum - View Single Post - ** J208 phone lock password how can I remove this ????

kungpaoski · 10-10-2009, 09:54

Succesfully detect unit in qualcomm mode. Read info and tried to reset MMI but still phone lock password. Any other way to resolve this????

PING: OK, COM4 - QCDI
Software: J208ZHGK1
Regions : HongKong
Language: en,zh
Release : 2007 November Rev: 1
Hardware: MP 0.901
IMEI: 358807-01-004426-7
BTID: 001E:7D:98604D
S/N : R3WPB03852
PRID: SGH-J208
CSID: TGY
SWID: ZHGK1
DATE: 2007-11-07
UNID: aaaaaaaaaaaaaaaaaaaaK5D1H13ACM(J200)
FLID: K5D1H13ACM(J200)
AXID: 1108-000129
Sysinfo Saved as:
J208ZHGK1_358807010044267_R3WPB03852_aaaaaaaaaaaaa aaaaaaaK5D1H13ACM(J200)_DFB82FFA_Sys.sec
Currently Unsupported Model
Unsupported Firmware or SIM not Inserted

PING: OK, COM120 - MODEM
MMI Reset Ok, Time: 00:00

Can I make full reset *2767*3855# ? Afriad might damage E2p. Might result in limited service?
Have made back up e2p/nvm but write e2p tab is not highlighted.

If I am to make read flash waht are the correct address to be used?

b.r.

10-10-2009, 09:54	#1 (permalink)
kungpaoski No Life Poster Join Date: Aug 2006 Location: Philippines Posts: 688 Member: 329609 Status: Offline Thanks Meter: 245	** J208 phone lock password how can I remove this ???? Succesfully detect unit in qualcomm mode. Read info and tried to reset MMI but still phone lock password. Any other way to resolve this???? PING: OK, COM4 - QCDI Software: J208ZHGK1 Regions : HongKong Language: en,zh Release : 2007 November Rev: 1 Hardware: MP 0.901 IMEI: 358807-01-004426-7 BTID: 001E:7D:98604D S/N : R3WPB03852 PRID: SGH-J208 CSID: TGY SWID: ZHGK1 DATE: 2007-11-07 UNID: aaaaaaaaaaaaaaaaaaaaK5D1H13ACM(J200) FLID: K5D1H13ACM(J200) AXID: 1108-000129 Sysinfo Saved as: J208ZHGK1_358807010044267_R3WPB03852_aaaaaaaaaaaaa aaaaaaaK5D1H13ACM(J200)_DFB82FFA_Sys.sec Currently Unsupported Model Unsupported Firmware or SIM not Inserted PING: OK, COM120 - MODEM MMI Reset Ok, Time: 00:00 Can I make full reset 27673855# ? Afriad might damage E2p. Might result in limited service? Have made back up e2p/nvm but write e2p tab is not highlighted. If I am to make read flash waht are the correct address to be used? b.r.