Can not initialize test mode ! Whenever i try to connect phone by soldering wires on board(TX RX GND) i get this error. Many boards have mentioned RX TX and GND on boards but i get this error by soldering wires. If i dont connect GND then i get this error without pressing Power Button and if i connect GND then nothing happen after pressing Power Button.
COM38 [VCP0] selected
module v3.11
Action: reset settings ("format ffs")
Model: Autodetect 6205-6227 NOR
Checking data, wait...
Phone should be Switched OFF !
Press and HOLD Power button now !
9600 autodetect
error: boot phase #2/1 failed
Can not initialize test mode !
Possible reasons:
1. communication fault, repeat required operation
2. ffs/eeprom is serious damaged, use repair ffs/eeprom files or use other unlock/format method
error: operation failed !
Finished, time used: 4 sec
Remove/Install battery now ! |