Unlock procedure C975 0.6.3.6

[pepik]

Note for steps for unlock C975 0.6.3.6 , E1070 :
On Smartlip Web page are this steps :



Boot 6.36
Check "Unlock automatically" - after prepare procedure phone will be unlocked

7. Log to bookmark "Prepare".
8. Select the appropriate model from SmartMoto list. Make sure that phone model and boot version of the phone to be unlocked exactly match the model and boot version stated in the list.
9. Press "Prepare" button.
10. The prepare cycle starts. SmartMoto creates a Temporary Backup File from the handset firmware.
11. At this time popup window appears at SmartMoto interface. Please follow the instructions provided therein
* Disconnect cable from the phone;
* Remove and insert phone’s battery;
* Press "Power on" key on the phone. Phone's LCD remains blank;
this step not work for me /after power on phone - phone start bootmode and next step give me error /
right step is :
connect phone /not power up/
* Connect cable to the phone;
* Press OK in SmartMoto.
12. The handset should be detected by SmartMoto as "S Blank..."
13. SmartMoto restores the temporary backup file.
next procedures unlock phone


If the option "Unlock automatically" was marked – the handset becomes unlocked.

[GSM_Support]

Most probably you are using a REPAIR cable...
Post the log plz. Hide the serials....

Best Regards
GSMServer team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[pepik]

i not use repair cable, i don ´t save log file

but

i try unlock E1070 and same problem with prepare procedure /use other USB cable/.

Step : "power on phone" not work for me /phone going to boot mode/
right step is connect phone /not power on phone/

E1070 0.6.7.1 after "Unlock OK" not unlocked

[GSM_Support]

С975 - definitely used REPAIR cable
Е1070 - you did not perform the PREPARE process correctly.

Best Regards
GSMServer team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com