iphone 3G MotherBoard Diagram - Page 2 - GSM-Forum

nafg · 06-12-2009, 16:26

Quote:

Originally Posted by sagar_lse

boss my cable is 100% ok becouse it's orginial cable and charger. same phone i try it's ok but my dead phone is not ok. i change three pis bettary . but after this phone use my bettary . my all of bettary is dameg. so boss i can't undastend what i do now. plzz help me..

comunication board is the problem change o jumper

br
nafg

nafg · 06-12-2009, 16:46

iphone 3g sim problem solution

br
nafg

Black_Daimond · 06-12-2009, 17:27

Quote:

Originally Posted by sagar_lse

boss my cable is 100% ok becouse it's orginial cable and charger. same phone i try it's ok but my dead phone is not ok. i change three pis bettary . but after this phone use my bettary . my all of bettary is dameg. so boss i can't undastend what i do now. plzz help me..

Buy I new iphone.
How can 3 battery be damage in 1 phone? Or is there something I did not understood.

It happend to me once, the connection to the battery was oxidated.
I opened Iphone, clean bat connector with contact cleaner, and after that phone was connecting and working 100%

sagar_lse · 06-12-2009, 17:46

boss all redy i do it but not ok plzz post another salution. plzz plzz plzz.

SLIPLOCK · 06-12-2009, 18:50

hi here,
is there some datasheet of the Intel NOR "PF38F3050M0Y0CE" please.
thanks in advance
wbr

kawaichang · 06-13-2009, 03:35

have you tried putting your phone on a DC power supply 'Sagar' and see if there are any power leakage? (the current sould be 0 for phones which dont boot up when battery is placed in. if there are anyting above .001 phone is leaking power prob try to sus out where the fault is)

also check your battery on a amp meter to see the vaultage. If the vaultage is = to 0amp try putting it on the power supply as well and charge it up, Clip red to red and black to black (set it on 3.7-4.2V) charge it until that battery reads its about .4XX amps (the current dial) and you now have a revived battery.

sagar_lse · 06-13-2009, 13:11

Quote:

Originally Posted by nafg

comunication board is the problem change o jumper

br
nafg

oh''''' boss many many many many thank's................

and thank's ***

boss 1 more help please... after make jumper my phone is on. when starding network searching but after few secend no service.

GNS_KUMAR73 · 06-13-2009, 14:55

plz help me ihave iphone 2g after power on show white light display only and itry to restore given err (1611)plz help what ido i try version 1.1.4/2.2.1 and other always given err 1611,1601,1604 difrent err every time and i tryed uper network board atteched another iphone its working fine i think problem is main board plz help what's problem in main board thanks in advance

sagar_lse · 06-15-2009, 07:22

Quote:

Originally Posted by nafg

comunication board is the problem change o jumper

br
nafg

boss now network probleam plzz help............

kawaichang · 06-16-2009, 02:18

Quote:

Originally Posted by GNS_KUMAR73

plz help me ihave iphone 2g after power on show white light display only and itry to restore given err (1611)plz help what ido i try version 1.1.4/2.2.1 and other always given err 1611,1601,1604 difrent err every time and i tryed uper network board atteched another iphone its working fine i think problem is main board plz help what's problem in main board thanks in advance

need to put phone in dfu mode and do a full restore for 1.1.4-2.2.1

dfu : (with usb cable in) press power+home button until screens blink, then release power button and hold for about 20sec. then should detect iphone in duf mode. hope this helps

kawaichang · 06-16-2009, 02:19

Quote:

Originally Posted by sagar_lse

boss now network probleam plzz help............

are the white cable connected ? the long one which runs from top of phone to the bottom.

kawaichang · 06-16-2009, 02:31

mr nafg

can u give me some advice on a iphone 3g (is been waterdamaged and cleaned up) but when i turn on phone its stays on with apple sign and then the circle loading sign and keeps turning. I cant detect or charge the phone as well on the computer, i have tried changing the usb connector cable with a few different ones and also tried reheating the usb/power controller and the power chip it self too.

Any thing u recomand i sould do..

thanks, kind regards

lxa786 · 06-16-2009, 02:52

Quote:

Originally Posted by nafg

other pic

br
nafg

thanks very much mate

quickgsm · 06-17-2009, 01:37

Quote:

Originally Posted by nafg

comunication board is the problem change o jumper

br
nafg

good working man nice job !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

sagar_lse · 07-21-2009, 07:23

hello every body i face new probleam in iPhone 3g. this phone all time dfu blank mood. when i restore it . full re store it but 99 % when go then errore 23 , after phone off again dfu blank mode. many time i try it and many version but problem is same. so now i think it's hardware problem. now what i do i can't undastend. please help me.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
iPhone 3G S Diagram Here	delower10	iPhone, iPad, iPod Hardware Repair	11	12-27-2010 14:57
IPhone 3g broken motherboard no service	Farntet	iPhone 4 / iPhone 4S	4	11-25-2010 11:51
iphone 3G MotherBoard Diagram------By {{{Rasel--Wingstel--Bangladesh}}}	Wingstel	iPhone 2 / iPhone 3G / iPhone 3GS	4	01-27-2010 12:26
iPhone 3G S Motherboard Diagram by parts	Zulea II	iPhone 2 / iPhone 3G / iPhone 3GS	0	11-23-2009 08:03

06-12-2009, 17:46	#19 (permalink)
sagar_lse No Life Poster Join Date: May 2008 Location: Bangladesh Posts: 987 Member: 777523 Status: Offline Sonork: 100.1584558 Thanks Meter: 335	boss all redy i do it but not ok plzz post another salution. plzz plzz plzz.

06-12-2009, 18:50	#20 (permalink)
SLIPLOCK No Life Poster Join Date: Oct 2004 Location: Galaxy Age: 46 Posts: 1,260 Member: 86301 Status: Offline Thanks Meter: 107	hi here, is there some datasheet of the Intel NOR "PF38F3050M0Y0CE" please. thanks in advance wbr

06-13-2009, 03:35	#21 (permalink)
kawaichang Freak Poster Join Date: Nov 2008 Posts: 134 Member: 895524 Status: Offline Thanks Meter: 33	have you tried putting your phone on a DC power supply 'Sagar' and see if there are any power leakage? (the current sould be 0 for phones which dont boot up when battery is placed in. if there are anyting above .001 phone is leaking power prob try to sus out where the fault is) also check your battery on a amp meter to see the vaultage. If the vaultage is = to 0amp try putting it on the power supply as well and charge it up, Clip red to red and black to black (set it on 3.7-4.2V) charge it until that battery reads its about .4XX amps (the current dial) and you now have a revived battery.

06-13-2009, 14:55	#23 (permalink)
GNS_KUMAR73 Freak Poster Join Date: Dec 2007 Location: canuaght place palika bazaar Posts: 243 Member: 647773 Status: Offline Sonork: 100.1611571 Thanks Meter: 65	plz help me ihave iphone 2g after power on show white light display only and itry to restore given err (1611)plz help what ido i try version 1.1.4/2.2.1 and other always given err 1611,1601,1604 difrent err every time and i tryed uper network board atteched another iphone its working fine i think problem is main board plz help what's problem in main board thanks in advance

06-16-2009, 02:31	#27 (permalink)
kawaichang Freak Poster Join Date: Nov 2008 Posts: 134 Member: 895524 Status: Offline Thanks Meter: 33	mr nafg can u give me some advice on a iphone 3g (is been waterdamaged and cleaned up) but when i turn on phone its stays on with apple sign and then the circle loading sign and keeps turning. I cant detect or charge the phone as well on the computer, i have tried changing the usb connector cable with a few different ones and also tried reheating the usb/power controller and the power chip it self too. Any thing u recomand i sould do.. thanks, kind regards

07-21-2009, 07:23	#30 (permalink)
sagar_lse No Life Poster Join Date: May 2008 Location: Bangladesh Posts: 987 Member: 777523 Status: Offline Sonork: 100.1584558 Thanks Meter: 335	hello every body i face new probleam in iPhone 3g. this phone all time dfu blank mood. when i restore it . full re store it but 99 % when go then errore 23 , after phone off again dfu blank mode. many time i try it and many version but problem is same. so now i think it's hardware problem. now what i do i can't undastend. please help me.