j100 unlock with smart clip doesnt work

[Mr.Tinkertrain]

@ fonelab,

Please ensure that the battery of the phone fully charged and run unlock procedure once again.
It suppose to be unlocked without any problems.



Best Regards
Smart-clip team
www.smart-clip.com
www.scoutdongle.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[fonelab]

Not working, 'Incorect pasword Try again'. Rx LED stay ON usually is blinking when unlockig. Smart Clip SW ver 4.08.
Phone:
J100i
SW ver: R10009
dsfNum:CDA102474/4 Rev:R2c
Ups

[harisa]

just use com cable some time uni box does't works.

[gsmtronica]

I had unlocked 2 pieces of J100 with smart clip and unlocked sucessfully, tested work 100%

[powerplay83]

What can i do if the phone begin to charge ??

[Mr.Tinkertrain]

@ powerplay83,

Please tell us what cable you are using, more likely that it is faulty.



Best Regards
Smart-clip team
www.smart-clip.com
www.scoutdongle.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[Rezn]

find schematic and build own cable.. very easy and will work 100% everytime.

[savinjcan]

I unlocked j100 ,light goes green ,but phone remain locked,tryin 10 times.

[Mr.Tinkertrain]

@ savinjcan,

What firmware version the hanset has?
What network provider is it locked to?



Best Regards
Smart-clip team
www.smart-clip.com
www.scoutdongle.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[yozgsm]

1. Power off the phone.
2. Connect the Clip to the phone using RJ45 cable (see pinout schematic below).
3. Press UNLOCK button.
4. Press Power button on the phone within 5 seconds after you press UNLOCK button on the Clip. RX/TX leds will blink.
5. E/G led will glow green on success.*

* After successful unlock (green led on) phones with inserted sim card may ask for PCK or NCK code. Enter 00000000 ("zero" 8 times).

• after unlock procedure done correctlly phone sill locked (tryed zero 6/8 time no luck)

• run procedure again but with one more thing:

• 1. Power off the phone.
  2. Connect the Clip to the phone using RJ45 cable (see pinout schematic below).
  3. Press UNLOCK button.
  4. Press Power button on the phone within 5 seconds after you press UNLOCK button on the Clip and keep it presed until e/g led will glow(rx/tx will glow .. not blink)
  5. E/G led will glow green on success.*
  * After successful unlock (green led on) phones with inserted sim card may ask for PCK or NCK code. Enter 00000000 ("zero" 8 times).
  • Pinout SE J100 (i've done this procedure with a non accepted sim card and a correctlly built j100 rj45 cable)